Suspicious Activity Detected

How to create a wireless bridge using an old router?

How to Use a Router as a Bridge
Please make sure that you read the Installation instructions very carefully. Connect a computer to the second router by using a patch network cable. Now you can connect all your wired devices to your wireless network, even if they're not next to your primary router. At the same time, a capable router may prove to be too expensive. Make sure that the network cable is plugged into one of the LAN ports usually 4 ports. Please see the following link for Supported Routers: Configure the Wireless Security.

Requirements

How to use an old router in order to create a wireless bridge

Navigate to the second router DD-WRT through an IP Address via a browser but read and setup the connection first using Important Notes at the bottom of this page and go to the status page and then go to the Wireless tab. Scroll down to access points and your WAP router should be listed there. Enter the admin credentials if prompted. On the computers using the Wireless Bridge open a command prompt: You will see an unidentified network with internet access when you hover over the wireless icon in the taskbar; this is the Wireless Bridge between the two routers and will be listed as a public network in Network and sharing centre.

If you wish to connect to the DD-WRT Control Panel on the second router you will need to connect a patch network cable to one of the LAN Ports on the second router and the other end to one of your computers and navigate as follows:.

Right click Local Area Connection and select properties. Manually assign the following information: Tweet 42, Total Views. If you are planning to expand your wireless home network and want it all wire-free and no cabling cluttering up your home, you may be able to turn a second wireless router into a Bridge; even an old router would do by using a DD-WRT free firmware.

Please see the following link for Supported Routers: Make sure to download the. In this Tutorial, we will use a Linksys Router; the router setting will be different than for other Routers D-Link, Netgear, Belkin, etc but with some similarities.

This is done by entering the IP address of the router into the address bar of a web browser To begin, turn off all these devices, start with the WAP, second router to be converted as Wireless Bridge and computer.

Connect a computer to the second router by using a patch network cable. Make sure that the network cable is plugged into one of the LAN ports usually 4 ports. Power up the second router and wait for the lights to stabilize then power up the computer. Go to the firmware update page and upload the firmware. On the Security tab check that the Firewall is set to disabled. Normally this task is done in unison with the routing task, but in a network that is using a separate router, you may want to configure an additional router to act as a bridge only.

Connect your computer to the router using an Ethernet cable. Follow the instructions in the router's manual to log in to the router's configuration application. This is done by entering the IP address of the router into the address bar of a Web browser. The IP address of the router will be something like Next, enter the username and password for the router. If successful, the main configuration page for the router will open in the window of the browser.

There will be an assortment of links on this page that will allow you to customize how the router operates. Locate the page that allows you to set the IP address of the router. This should be set to something other than the default address, and it must not be the same as any other device on the network.

Both severs will need to be disabled because the main router on the network will now be in charge of assigning IP addresses and translating network addresses. Disable all of the access controls and the firewall of the router to be used as a bridge.

Video of the Day